Simulation
- The circuit simulated is as shown in the below image.
- Click the input switches
to select the required inputs named "x", "y", "z" and "w". - The simulation will display corresponding output. Output is displayed as a glowing bulb
- Press the "RUN" button to display the output in the truth table.
- "reset" button clears all entries of truth table.
- At specific positions, small switches
make the lines stuck-at-0. Clicking them simulates SA0 faults at the said locations. - Repeat above steps for all possible inputs and verify the truth table
D0
D1
D2
D3
D4
D5
D6
D7
D8
D9
D10
D11
D12
D13
D14
D15
Truth Table
| w | x | y | z | Normal output | Faulty output |